In the 3.6% of patients undergoing the valve-in-valve procedure to fix a leak, the most common type of device malposition was deployment that was too low inside the left ventricular outflow tract (

Went on one call today and had another query by Facebook about this so I though why not write an article about it. Both persons were very concerned as they saw water dripping from theirs boilers. A

Pre-reaction of epoxy resin to meet the requirements under Art, design pre-reactor temperature control loop. To the reactor using two co-accused of the variable temperature adjustment bamboo to ac

needle valves are used in flow metering applications, when a constant calibrated, low flow rate must be maintained for some time, as in the case of the idle fuel flow in a carburetor. The orifice is

This new ball valve is an innovative solution for gas, sewer and water applications where metal ball valves have typically been installed. The ball valve is 50 percent lighter than comparable m

When system pressure at the check valve inlet port is high enough to overcome the biasing spring force on the poppet, China globe valve the poppet is pushed off its seat allowing oil to flow through t

A Pneumatic Control Valve is a valve that works via compressed gas to limit a device, preventing overloads, explosions or any number of other harmful effects. Newer control valves work through senso

Electric hard sealing butterfly gold, chemical industry, building materials, power stations, glass industries of the ventilation, environmental protection engineering cold or hot blast dongshen gas