We are working on an LNG plant and have been having a discussion within the team relating to valves for use in cold service

The purpose of a fire-safe valve is to prevent or hinder flammabel fluid (liquid or gas or gases formed from liqid phase)to pass, at least for a given time and at least during that periode not in crit

I'm wondering if anyone has any ideas.Exhibit A, shall we say, is a 3 way actuated valve, with an ITT tag, I would say of European descent.

I have a problem with MOV motor operated valve paaing through. when I looked at the MOV data sheet, it was not speified that the valve as Tight Seal Closed but it is referred the seat leakage rate to

i am working on a unidirectional pipe prover and i need to design and purchase the launching and receiving chamber.

I have to calculate the required Cv for a blowdown valve.The fluid is boiler feed water. I know the mass flow, pressure and temperature input and output, corresponding to saturated steam (eg 50 bar, 2

wondering if any of you can point me in the direction of some info regarding test rig design.I'm considering setting up in business and need a test rig for small "kunkle" type safety valves.

I have 18" globe control valve to be installed on sea water line. However required upstream and downstream length is not available on platform.